Product Description
Description: Seal Leak Detector/110-120V/2NO/DIN rail
| Product Information | Resources |
|
|
| Specifications |
| Product Attribute | Attribute Value |
| Input Voltage (V) | 110 - 120 Vac nominal |
| Maximum Input Power | 2 |
| Input AC Line Frequency (Hz) | 50 / 60 (50 will increase all delay timers by 20%) |
| Output Form | DPST - 2 Form A |
| Output Load Rating (VA) | Pilot Duty: 360 VA @ 240 Vac B300; General Purpose: 8 A @ 240 Vac |
| Sense Voltage | 5 Vdc continuous (probe) |
| Sensitivity (Ohms) | 4.7 - 100 |
| Protection Class | IP20; NEMA 1 (finger safe) |
| Termination Type | Torque: 6 in-lbs; Wire: Stranded or solid 12 - 20 AWG |
| Mounting Method | 35mm DIN rail or Surface Mount (#6 or #8 screws) |
| Operating Temperature | -40° to 70°C (-40° to 158°F) |
| Storage Temperature (F/C) | -40° to 80°C (-40° to 176°F) |
| Humidity | 10 - 95% non-condensing per IEC 68-2-3 |
| Dimensions | 3.5 H x 2.08 W x 2.35 D in. (88.9 x 52.9 x 59.7 mm) |
| Series Features |
| 460-15-100-SLD - Single-Channel Seal-Leak Detector |
| Series Description: The 460-15-100-SLD is a seal-leak detector to sense seal failures on submersible pumps. A microcontroller-based relay monitors the shaft seal of a submersible pump motor. A resistive probe is installed in the seal cavity. If water leaks into the pump, the resistance measured by the probe decreases. When the resistance drops below the sensitivity setpoint, the unit will trip and the relay contacts will change state. Output relay logic can be reversed by removing an external jumper. The unit will automatically reset when a fault is cleared. |
|